Well they are finally here & turned out very good. They are a good quality heavy vinyl with UV coating.
I'd like to again thank jantje for the graphics work & zstrom for the printing interface. Couldn't have got it done without these two.They are available in either white or yellow reflective background & are about 4 3/8" (111 mm) from corner to corner as mounted.
The forum support donation is
$4.50 USD for each sticker plus shipping.
Shipping for any number of stickers to US is
$0.50 USD.
Shipping for any number of stickers to Canada is
$0.75 USD.
Shipping for any number of stickers to the rest of the world is
$1.00 USD.
I don't want to start up another Paypal account, so we'll use the present VSRI donation account. As per example below,
click the donate button at the bottom of the main forum page & just enter the items you want in the
'Purpose' box, enter the total amount (including shipping) & be sure to click the
'Update Total' button before continuing. If you would also include your username in the purpose box it would be helpful. You don't have to be a Paypal member to use Paypal as a debit or credit card will work with this account.
The $14.00 in the below example is for 3 stickers + US shipping & is just an example. You need to calculate your own total as per above. $4.50 USD for each sticker + correct shipping to your designation.
If you don't want to use Paypal, send check or money order with note of items wanted & a good return address to:
John Weldon
2729 Jobee Dr
Charleston, SC 29414
USA
Sticker examples:
Sticker examples mounted out in the daylight:
Installation Instructions: 1. Clean the area sticker is to be applied too using rubbing alcohol or equivalent & let dry.
2. Peal one corner away from the backing paper and apply to surface. Slowly continue applying while removing backing paper as you go until entire sticker is laid down. The glue on these stickers is good, so if you let it hit the surface incorrectly it will be hard to remove. Press firmly with hand pressure over entire sticker.
3. Enjoy.
These stickers are fairly thick and are not pron to an air bubble problem when applying. If you manage to get a air bubble, just use a credit card or such and work the bubble out to the closest edge.
Note: Some thought went into the design of these VSRI stickers, mostly good glue (may be a bit hard to get off), rounded corners to prevent premature lifting & UV coating. The glue is good enough that they can be applied to a slightly marbled surface such as a GIVI case.
